LOADING...

Recommmadation For Aggregate Impact Value Test Pdf

(PDF) DETERMINATION OF AGGREGATE IMPACT

Scope: This Part of BS 812 describes methods for the determination of the aggregate impact value (AIV) which gives a relative measure of the resistance of an aggregate to sudden shock or impact. Principle A test specimen is compacted, in a

(PDF) AGGREGATE IMPACT TEST ResearchGate

[Show full abstract] each sieve is added and subtracted by 100 gives the value of fine aggregate. Higher the aggregate size higher the Fineness modulus hence fineness modulus of coarse aggregate

IMPACT VALUE OF AGGREGATE iricen.gov.in

2019-3-11  The aggregate impact value gives a relative measure of the resistance of an aggregate to sudden shock or impact, which in some aggregates differs from its resistance to a slow compressive load. 2.Apparatus Required Fig. 1: Balance Balance should be accurate upto 1 g Fig. 2: Sieves Seives required are 12.5, 10.0 and 2.36 mm Fig. 3: Impact

(DOC) AGGREGATE IMPACT VALUE TEST hong

The aggregate impact value indicates a relative measure of the resistance of aggregate to a sudden shock or an impact, which in some aggregates differs from its resistance to a slow compressive load. The method of test covers the procedure for determining the aggregate impact value of coarse aggregates.

DETERMINATION OF AGGREGATE CRUSHING VALUE

2017-5-29  This characteristic is measured by impact value test. The aggregate impact value is a measure of resistance to sudden impact or shock, which may differ from its resistance to gradually applied compressive load. 3. APPARATUS The apparatus of the aggregate impact value test as per IS: 2386 (Part IV) 1963

Aggregate Impact Value Test, Procedure, Result &

2021-2-25  Also, it can be defined as the resistance of aggregate to failure by impact load is known as the Impact Value of Aggregate.. The Characteristics of any material to resist sudden impact is known as toughness. When we use aggregate in roads and pavement on which vehicular movement is done and there is a possibility of impact load on aggregate.

Aggregate Impact value Test Apparatus, Procedure

2 天前  Aggregate impact value test set-up Procedure of Aggregate Impact value test The test sample: normally aggregates sized 10.0 mm to 12.5 mm. the aggregates should be dried by heating at 100-110 0C for a period of 4 hours

Impact Test Of Aggregate Lab Test Procedure

The procedure of the impact value test includes the following series of steps: 1. The aggregate samples of size 10mm to 12.5mm (passing through 12.5mm sieve and retained on 10mm sieve) are first taken and oven-dried at a temperature ranging from 100 degree Celsius to 110 degree Celsius for about four hours.

IS 2386-4 (1963): Methods of test for aggregates for

2018-2-1  IS : 2386 (Part IV) ‘- 1963 2.2 Apparatus The apparatus for the standard test shall consist of following : a) A 15-cm diameter open-ended steel cylinder, with plunger and base-plate, of the general form and dimensions shown in Fig. 1.